COLORS: 21 color

CALIBERS: 40,45,50,55,60,65,70,75,80,90,100,110,120 mm

DELIVERED in rolls by 500 m

MARKING multi-colored printing

 

Stage I.Preparation

While wrapping of the roll, cutting into pieces it is required to avoid rubbing of the butt end of the roll of any surfaces. It should perform wrapping off the roll in a vertical position only while leaning it onto a cartoon frame. Soak in water at temperature 18-25°С for 30 minutes.

(!) DO NOT SOAK IN WARM WATER TO AVOID SHIRRING OF THE CASING

While using of the casing in cuts while soaking spilling of water throught the sleeve is necessaty to perform. It is necessaty to soak shirred casing not taking off the net in water at temperature 18-25 °С for 40-60 minutes, while entirely dipping into water.

Stage II. Stuffing

Forming of sausage products can be done by any stuffers: manual and automatic. Overstuffing of the casing 10% from nominal diameter (see the Table);

Table of Recommended Calibers for Stuffing 

StageIII. Clipping

Both manual and automatic clippers can be used.

Stage IV. Heat treatment

While manufacturing of cooked sausages it is necessary to decrease the quantity of water to be added to the moisture loss quantity for heat treatment, due to strong barrier qualities of the casing. This let to exclude the formation of water and fat pockets and breaks of the casing while heat treating, and the output of the product will not change. Usage of additives when composition of farce for cooked sausages requires a special attention on the follwing cycles of the technological process. The increse of moisture keeping capability of meat will lead to an intense swelling of proteins, which helps to increse inner pressure of farce onto the casing's walls during heat treatment.

While cooking in stationary steamers:

Put the sausage sticks into the water at temperature 55-60°С to avoid non-controlled shirring and deformation of the sausage sticks . Sausage products are to be constantly kept under the water and moved for even cooking. Before loading of each new lot of sausages it is recommended to decrese the temperature of the water in a steamer up to 60°С.

While heat treating in heat chambers: ecxlude the processes of drying and roasting.

PROCESS	Temperature in a chamber,°С	Temperature inside a sausage stick, °С	Duration, min	Relative humidity, %
Step cooking
I step	50-55	-----	10	100
II step	65-70	-----	15	100
III step	78-85	-----	15	100

(!) IT IS STRONGLY PROHIBITED TO STRICK THE SAUSAGE STICKS 

Stage V. Cooling

Firstly, spraying is made by cold water and, secondly, cooling in the air.

CONDITIONS OF STORAGE

Store in the manufacturer's package in closed, clean and dry premises, odour free, protected from sunlight, at the dostance not less than 1 m from the heaters, at temperature not ebove 25ºС and relative humidity not above 75%.

(!) IT IS STRONGLY PROHIBITED TO THROW AND EXPOSE TO HITS BOXES WITH A CASING

The casing, which was stored at temperature below 0ºС should be kept at room temperature for not less that 24 hours before opening of the package.

TERMS OF STORAGE

1 year from the date of manufacturing at the condition of the preservance of the manufacturer's package integrity.